Follow me on my project as I purchase a Yamaha XS650, get it running and registered and then chop it into what hopefully is a sweet scoot that I can get out on and tear up the roads.

Sunday, March 7, 2010

Parts order and my costs so far

This afternoon I placed my first order for parts that I know I will need for the bike to run/pass rego. Below is my list of parts that I have ordered:

Sump filter
Sump gasket
Oil Filter screen
Carb Rebuld kit
Main Jet washer
pilot jet rubber plug
pilot jets
float bowl screws
Top cover screws
Carb holder set
Carb clamp
stainless holder screws
Blind plug
Pod filters
inline square fuel filter
cable luber
gas cap rubber seal
brake rebuilt kit
bleed screws
caliper sleeve boot
Rotor puller
Timing light


This came to a total of $281 USD plus $46.43 shipping. My Total came to a total of $361.50 AUD for the parts.

I know that I will later be ordering a Pamco Ignition ($199 with everything I need) plus at least a few copper gaskets and probably a few bearings, so I am not done yet.

My current project costs sit at me being $195 out of pocket. I think I am doing alright so far.

No comments:

Post a Comment